GlareStomper Official Site,GPS Anti Glare,GPS Visors,GPS Shades

GlareStomper^®

Reduce Glare on Your GPS Display!
Automotive | Motorcycle | Aircraft | Watercraft

Sponsors

GPS Sun Shade Visors
For Tomtom GPS, Magellan GPS, Garmin GPS, etc.

'Relatively' Simple Instructions

Clean the unit to remove any dirt, oils or manufacturing 'release agents' that may remain on the plastic case. We recommend a good lens cleaner for this.
Determine where to place the Velcro^©on your unit.
Cut the Velcro^© (if required) so as not to pass over card slots or other controls.
Remove the Velcro^© adhesive backing (avoid touching the adhesive as much as possible).
Place the Velcro^© strips on the unit as far toward front as possible - press firmly to secure.
Allow the adhesive to cure 24 hours before attaching the sun shade.

NOTE: Because the sun shade is flexible, on/off push buttons can be activated by pressing on the shade in the area where it passes over the switch. The visor may also be cut to allow access to other connections if needed. This will not harm the visor - won't fray or unravel. DOES NOT void our satisfaction guarantee in any way.

Very Detailed Instructions Here
Opens in Adobe Acrobat

Kindle Fire Instructions

Cut supplied Velcro into 4 pieces as follows:

A. One piece 1.75 inches
B. One piece 1.5 inches
C.Two pieces 4.25 inches

Hold the Fire with the speakers at the top, screen facing you. PRESS in place piece 'A' between the speakers. PRESS in place piece 'B' on the bottom to the left of the phone jack. PRESS in place pieces 'C' on each side toward the top.

ALLOW THE VELCRO TO 'CURE' 24 HRS.

You can now attach the visor on the long side or the short side. Be sure to center the visor when attaching it. The visor can also be creased to make it more square at the corners. To fold the visor, push the sides in, and then fold the top down. Secure the folded visor with the Velcro tabs.

MORE TIPS!

Chin Strap Method!
When it's not practical to place adhesive Velcro on the sides of your GPS unit!

NOTE: We DO NOT supply the non-adhesive 'fuzzy' Velcro needed for this method.
It is commonly available at almost any store if you need it.

Place adhesive Velcro (1) on the top of the unit ONLY, avoiding switches.
Take advantage of the ‘hook’ patches (3) located on each end of the visor (2).
Use a length of 'LOOP' (fuzzy) Velcro (4), attach it to one side of the visor (at the bottom) (3).
Run this underneath the unit to the other side of the visor, pull it tight and attach it to the other side of the visor (at the bottom) (3).

This will hold the sides in place (like a chin strap on a helmet).

FOR MOTORCYCLES